If you hear a slight click inside the door after depressing the switch the switch is working. Put your ear against the sliding door with the fuel door open. If it doesn’t unlock it is likely the actuator. It will unlock if it’s a fuel door switch problem and the door will open slightly when you pull the handle. 1 holding the door lock up for 5-10 seconds. There’s a few tricks for ruling out the door switch when the door lock is stuck. I was searching for a fix and came across your post and really want others to know to listen to people’s symptoms and when the problem started occurring. It was the door lock actuator and NOT The fuel door switch. A lovely little boy playing with the locks and then the door would not unlock manually or with the power switch. Old thread, but I was very frustrated no one addressed the symptoms and the kiddo aspect. If someone apologizes to Melissa for not listening, I’ll even share the secret of how to open the door when it won’t unlock so you can take off the panel and replace the actuator. No sound means the switch is not working.ģ. If it doesn’t unlock it is likely the actuator.Ģ. There’s a few tricks for ruling out the door switch when the door lock is stuck.ġ holding the door lock up for 5-10 seconds. So, it's a feature, not a bug!Ĭlick to expand. Repeated tests showed the lever has 'catch' feel to it when you pull it up. The cap wasn't open or obvious but that is what it was. Later at home it still won't work so I read up on how the doors work and it turns out the gas cap has a lock-out-you knew it had to- so out I went and pulled on the gas release tab (no friction or 'catch' felt on that action), the cap opened and I closed it and tried the locks and they work! Yea. To test, I toggled the driver door lock switch and all doors lock/unlock except the driver side sliding door (can't see the passenger side lock, but that door works anyway). I pushed the manual lock open and pulled the handle and the door opened. Ah ha! The problem is that it won't unlock. you know, when you have four kids in the van in a parking lot and the door won't open and you push buttons and pull handles and it just won't open. Today the passenger side door would not unlock. Just try toggling the gas cap release lever and make sure the cap is shut ('01 Ody). I know NOT to touch sandpaper on them but is there anything better than eraser and/or alcohol? I hope it lasts for a while.Īnybody got a better solution? My door junction blocks are still the original 1999. I used the eraser again and now both lock and unlock started working. So there must be separate pin connection in the door for unlock and lock. While the door was open, I tried locking and unlocking and then I realized that when the door is open, it is completely electrically isolated. I verified the fuel door interlock mechanism but that was working fine. After using the eraser trick, the beeping stopped but later the driver door would not unlock. Over the weekend, I had one door beeping on turns. I had to clean it with alcohol before the doors would work again. I do recall that once I had tried to use DeOxite but it actually started causing lots of problems. I am finding that I need to use the eraser cleaning more often, at least every six months or more often. Where is the "official" door topic? I am looking for a "magical" solution to maintain the door contact.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |